Here s how to install click lock engineered hardwood flooring.
Laying hardwood over hardwood.
Put the first board up against the mason s line with the groove side facing away from the walls.
In either case roll the film flat or walk it in stepping on every square foot to ensure adhesion.
Puncture bubbles to release trapped air.
Newly fastened floors over existing wood floors should be installed opposite example photo right or at a 45 degree angle to the original direction.
If your laminate has a built in underlayer you may install it right on top of the hardwood.
Laminate flooring can be installed directly over hardwood often with no preparation necessary.
Can i install new hardwood over a floating floor.
New hardwood flooring over old hardwood flooring.
If the hardwood flooring is installed nailed down parallel to the direction of the old wood flooring the new wood floors could pull apart leaving open gaps or develop waviness later if the old wood flooring under it expands or contracts.
Face nail each board at the point of every joist and set the nail with a nail set.
3 4 thick or thinner solid or engineered hardwood flooring must be installed across the old wood floor boards at a 90 degree angle.
When installing new wood flooring parallel to an existing solid nail down floor add a minimum of 3 8 plywood underlayment over the existing floor to increase stability.
If the new flooring does not have the built in underlayer simply roll out and tape your underlayment to the wood floor and begin installing the laminate.
Check with the flooring manufacturer for recommendations.
If you re dead set on keeping the original direction a minimum 3 8 plywood sub floor should be installed over the older floor.
With shaw floors new line of floorté waterproof hardwood i was able to install real hardwood flooring directly over my existing floors without any demo or prep work.
Lay 4 to 6 mil polyethylene film over the slab overlapping the edges 4 to 6.
Install the plywood after the vapor retarder is in place.
If your subfloor is already hardwood but you want to improve the look of your home with new material it is possible to lay engineered hardwood over the existing floor with proper preparation and traditional installation techniques.
Align the edge of the board with the chalk line and drill pilot holes down through the hardwood plank and into the sub floor and joist.