Metal Hip Roof Ridge Cap Installation

How to install hip caps for an exposed fastener vicwest metal roof.

Metal hip roof ridge cap installation.

Metal roofing ridge cap installation steps. Apply butyl tape sealant at to the inside of the chalk line on both sides of the ridge cap. First we re going to put the hip cap in place and mark it so that we can prepare the end here at the eave and the top at the ridge. You cut z trims for the top of your panels.

The ridge cap is the last thing to put on when installing a metal roof. The good thing about hips in contrast to valleys is that water runs away from rather than toward them. See the illustration below. Although ridge caps can come as shingles and may have a feature such as the ability to self vent or include a skylight the.

For a longer ridge move along the ridge repeating. Applicable for ultravic supervic 7 8 corrugated barnmaster. I just installed the last piece of z trim and now we re ready to install the hip cap. Center a piece of ridge cap on the building peak.

What can i do to seal these gaps. I am installing a metal hip roof and am concerned about the possibility of leakage around the hip caps seams. With new laminated hip and ridge cap shingles finishing a roof installation with a ridge cap is a much simpler process than with the old three tab shingles. If the ridge is only 15 20 long repeat step 1 at the opposite end of the ridge.

The installation of the ridge cap is the same as the hip cap. And on the other side the ridge is closed. Preparing the eave ridge cap ends. How to install ridge cap foam closures on a metal roof for a non vented ridge cap.

We use a z trim and make sure to have tape seal underneath the z trim and between the ridge cap and the top of the z. We re going to get the hip cap in place and let it overhang at the eave so that i can make. The ridge cap covers the seams but leaves gaps underneath due to the ridged profile of the roofing. In summary to install the ridge cap shingles you simply separate them where they are perforated bend them over the peak and nail them down.

You use your ridge cap to mark the ribs so that you know where to place the z.