I unhooked the line at the motor and blew it out with an air compressor to be sure there was.
Mercury water pressure gauge not working.
228 engine sensor shift pressure sensor is not working properly.
Controls and gauges that have to face the ultimate test.
Fix 2003 mercury 90 four stroke with water pressure gauge i removed the connection hose to the gauge on the dash side i removed the connection hose on the motor side.
I had to use a mirror and a flashlight to view it.
My water pump gauge quit working last month.
I brought it to the dealer they said the gauge was bad so i ordered a new gauge from ranger still under warranty i replaced the gauge still not working.
Free shipping by amazon.
If the oil pressure coolant charge or gas gauge doesn t work or works erratically the problem is in the gauge wiring or sender.
Get it as soon as thu oct 8.
Non critical service engine soon.
Getting past a mercury engineer is no easy task.
This problem is easy to fix with one simple tool.
Get it as soon as thu oct 8.
The old gauge was hung on 7 psi.
Speedometers are unique in that some of them use physical cables instead of sensors so a speedometer not working can also indicate a broken cable or stripped gear.
Your outboard has a water pressure speedometer located on the lower unit of your motor.
Mercury water pressure gauge not working.
Often up to 1 000 total hours before the control or gauge is fully certified by mercury engineering.
Posted 10 16 2009 03 38 pm et us on my 180 dauntless with a mercury 115 fourstroke i have replaced the water pressure gauge.
229 engine sensor shift pressure sensor is not working properly.
The mechanic guessed it was the gauge because my engine is pissing water very strongly.
Water came out next i looked inside the hose connection on the motor side.
Faria 12828 euro trim gauge for mercury mariner 3003 343 4 3 out of 5 stars 30.
Non critical service engine soon.
And worthy of your boat.
Faria 13003 coral water pressure gauge kit 30 psi 2 4 5 out of 5 stars 11.
Non critical service engine soon.
I used canned air to blow it through.
An individual gauge doesn t work.
The new gauge does not work either.
Any help is appreciated i have a 2010 ranger z521 powered by a 2009 yamaha 250 hpdi series 2.
From time to time this feature will get clogged with debris weeds and gravel.